Guide Manual
----- ST9301 Remote Control
Remote Control Application
Components
① Unlock
② Numeric Key
③ Function
（
FN
）
④ Indicator
⑤ IR Emitter
⑥ Lacing Hole
⑦ Battery Carrier
Change the Battery
1.
Pull out the battery carrier
2.
Put CR2025 battery inside (negative pole upwards)
3.
Push the battery carrier inside
4.
Press “FN” button to re-activate the remote controller after battery change
Remark:
Indicator will blink once when “FN” button is properly pressed; if the controller is not re-activated, it’s not workable;
Battery standby lifetime is max 2 years.
Disarm the Display Security Alarm
1.
Make sure the remote controller indicator is OFF
2.
Make sure the remote controller is matched with display security properly
(For the inconformity situation, please refer to details below)
3.
Aim the controller IR emitter to display security IR receiver
4.
Press “Unlock” button with 5-50cm distance
5.
Repeat the above steps for other alarming display security
6.
Remark: The alarm can be only disarmed after 5 seconds to avoid shoplift.
