S
UPER
C
LASS-
D
S
ERIES
A
MPLIFIER
10
Owner’s Manual / Installation Guide
M
ODEL
: S2000.2D
FULL RANGE MONO
This application illustrates the basic mono bridging
method for all 2 channel amplifiers.
Interconnect cable checklist :
A MONO signal source is required, such as would be
available from the mono sub bass output of an active
crossover, whether stand alone, or built into a head unit
or equalizer.
Important
: Do not be tempted to connect
the hot, or positive outputs, from any source together to
obtain a mono signal, as this could very well damage the
output stage of that source.
It is necessary to feed the SAME signal to both left and
right inputs via a Adapter RCA cable. Connect the mono
speaker positive terminal to the CH1+, and its negative
terminal to CH2-.
Crossover frequency control setting checklist :
N/A for full range operation.
TIP
: If you are using the mono sub bass output of an
active crossover, there is nothing wrong with
switching in the low pass filter in these
amplifiers for a steeper low pass roll-off.
Minimum final loudspeaker impedance :
- 4-Ohms mono.
Switch setting checklist :
- The
AMPLIFIER X-OVER
switch must be in the BP
position.
Bass Boost
Powe r
0dB
1 8dB
S2000.2D
FUSE
POWER INPUT
GND
REM
BATT +12V
SPEAKER OUTPUT
CH1
MONO
-
+
CH2
-
+
+
-
REMOTE
LEVEL
LOW PASS
6V
0.2 50Hz
X-OVER
BP FULL HI
HI PASS
50Hz
4K
4K
LINE INPUT
CH1
CH1
CH2
CH2
HIGH INPUT
SUB WOOFER
4 - 8 Ohms
+
-
Fuse
(2)
Near Battery
(3)
Remote Turm-ON is
connected to Radio's power
antenna lead or a swit12V
(1)
-
+
BATTERY