Snapper 2300 PSI Pressure Washer
9
How to Use Adjustable Nozzle
You should now know how to START and STOP your
pressure washer.The information in this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
1.
Slide nozzle forward when you wish to adjust spray to
low pressure mode (Figure 9). Slide nozzle backward
to achieve high pressure.
2.
Point nozzle down towards a firm surface and press
trigger to test spray pattern (Figure 10).
3.
Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 11).
4.
For most effective cleaning, keep spray nozzle from
8 to 24 inches away from cleaning surface.
5.
If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
6.
DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent, follow these steps:
1.
Review use of adjustable nozzles.
2.
Prepare detergent solution as required by job.
3.
Place filter end of chemical injection hose into
detergent container.
Slide nozzle backward
for High Pressure
Mode
Slide nozzle forward for low
pressure mode and
detergent application
Figure 9 — Adjusting Nozzle for Pressure
Figure 10 — Testing the Spray Pattern
Figure 11 — Adjusting the Nozzle for Spray Pattern
Rotate nozzle
counterclockwise for fan
spray pattern
Rotate nozzle clockwise
for narrow spray pattern
CAUTION
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
You must attach all hoses before you start the engine.
CAUTION
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
Keep the chemical injection tube from coming in contact
with the hot muffler.