4
SECURE
ENGAGE THE DOGS
After inserting the speaker into the wall or ceiling opening, turn the
screw for each of the dogs one quarter turn clockwise to engage the
spring mechanism.
The speaker is now held in place, freeing up your hands so that you may
continue to tighten the dogs safely.
TIGHTEN THE DOGS
Continue to tighten the dogs until you feel resistance, but do not over-
tighten. If using a drill, use a low-torque setting.
CONNECT
Strip the insulation on each conductor approximately ¼” and insert into
the speaker terminals. Ensure that there are no stray strands of wire
protruding from the connectors.
Observe proper polarity (+ to + and – to – for each speaker and at the
amplifier).
When wiring a dual voice coil speaker, refer to the dual voice coil wiring
configuration image below.
For help with impedance, system design ideas, or wiring recommendations,
see our website or contact us.
Amp
Amp (Left)
Amp (Right)
DUAL VOICE COIL
Amp
Amp (Left)
Amp (Right)
SINGLE VOICE COIL
