107
M2 Scope/Meter
M2 Scope/Meter Remote Operation
Channel Selections
The channel selection mode allows you to switch the trace on and off. The F2 key controls the
channel 1 trace and the F3 key controls the channel 2 trace. Pressing the key the first time turns
this channel “off” and the sweep signal is removed from the display. Pressing the key a second
time puts this channel back onto the display. The previous characteristics for this channel are
saved during this process. The indicator at the base of the screen appears as inverse video (white
lettering on a black background) when a channel is on.
Figure 8-19
Sample screen with channel 1 on and channel 2 off
8.4 M2 Scope/Meter Remote Operation
The M2 Scope/Meter can be used remotely (wireless connection), allowing you to operate your
M2 Scope/Meter using your Diagnostic Tool.
The M2 Scope/Meter needs to be paired (connected) to the Diagnostic Tool for remote operation.
The following procedures describe the configuration and setup of the M2 Scope/Meter for remote
use with a Diagnostic Tool.
8.4.1 Remote Functions Setting
The Remote Functions setting is used to setup and connect the M2 Scope/Meter to the Diagnostic
Tool (
The rotary switch Remote Functions setting is used:
•
To pair the M2 Scope/Meter to the Diagnostic Tool, see
M2 Scope/Meter Remote Operation
•
To remotely connect the M2 Scope/Meter to the Diagnostic Tool, see
'
'
'
&+
'&
P6
7$872
7&+
9
9'LY
7
'
$I
$IBOOFM
$I