
113
System Settings Operations
Synchronizing Wireless Communications
The Hardware Status indicators in the lower-right corner of the Home screen provides a quick
reference of which modules have been paired to the Display Device (
12.1.1 Pairing the SCAN MODULE
The SCAN MODULE needs to be either connected to a vehicle or connected to a powered USB
port so that it is powered up during the synchronization procedure. Make sure the VERDICT
Display Device has a charged battery or is connected to an AC power supply.
z
To pair the Scanner with the Display Device:
1.
Power on the VERDICT Display Device.
2.
Connect the 25-pin end of the data cable to the Scanner data cable port.
3.
Connect the 16-pin end of the data cable to a live vehicle data link connector (DLC).
The green vehicle power LED should be illuminated.
4.
Tap the
System Settings
button on the Home screen of the Display Device.
5.
Select
Paired Devices
from the menu.
6.
From the Paired Devices screen select
Add
from the toolbar.
7.
When prompted select
OK
from the toolbar.
The Display Device searches for compatible wireless devices, then displays the results. The
SCAN MODULE is listed as “VERDICT S3-” plus a partial serial number (
Figure 12-2 Sample SCAN MODULE selection
Table 12-1 Hardware Status indicators
Module
Not Paired
Paired
Scanner
Data Acquisition
Summary of Contents for VERDICT D7
Page 1: ...User Manual May 2011 EAZ0063L05C Rev B ...
Page 3: ...iii ...