Snap-On ELITE, User Manual

Page: 30 / 84

20
Settings Settings Menu
5.2.1 Wi-Fi Connection
The diagnostic thermal imager is equipped with the ability to connect to a Wi-Fi network, however
the connection is solely dedicated to our ALTUS cloud-based image storage/sharing website, see
ALTUS (ALTUSDRIVE.com) - Image Sharing/Storage on page 41.
Before you can use ALTUS, Wi-Fi must be turned on and the device must be connected to a
wireless network.
z
Connecting the thermal imager to a Wi-Fi network:
Selecting Wi-Fi Connection from the settings menu allows you to turn Wi-Fi on/off and select a
wireless network ( Figure 5-4 ).
1. Turn on the thermal imager and press the Menu button.
2. From the toolbar select the Settings icon.
3. Select Wi-Fi Connection from the menu.
4. To turn Wi-Fi on/off, press the UP control button to select the Wi-Fi Power icon , then press the
Y button to turn (toggle) Wi-Fi on/off ( Figure 5-4 ).
Figure 5-4
Wi-Fi On/Off / Network Selection
5. Press the Down control button to enter the Wi-Fi network list, then use the Up / Down control
buttons to select a wireless network. Press the Y button to enable the selection ( Figure 5-4 ).
6. If a password is required when choosing a secured (protected) network, enter the
password using the on-screen keyboard and the directional control buttons. Select the “ enter/
done ” key when finished ( Figure 5-5 ).