Page 25
Operation Manual
5.4 MOUNTING AND DEMOUNTING MOTORCYCLE
TIRES
To mount and demount motorcycle/ ATV or motor-scoter
wheels it is necessary to utilize the optional 8” motorcycle
jaws.
The bead-breaking, mounting and demounting technique
is the same as per the car, tubeless or tube-type tires.
NOTICE!
MOTORCYCLE RIMS MUST ALWAYS BE CLAMPED
FROM THE OUTSIDE. AIR PRESSURE MUST
NOT EXCEED 110 PSI (8 BAR) WHEN CLAMPING
MOTORCYCLE RIMS.
6.0 MAINTENANCE
BEFORE STARTING ANY MAINTENANCE OPERATION
ENSURE THAT THE MACHINE IS DISCONNECTED
FROM THE AIR AND ELECTRIC SUPPLY.
A.
Periodically clean the vertical hexagonal rod with liquid
detergent. After this immediately lubricate with a light
lubricating oil (Fig. 6.0-1).
1106
Fig. 6.0-1
B.
Periodically clean all moving metal parts and lubricate
with oil.
C.
Weekly clean the teeth of the jaws (
1
Fig. 6.0-2) with
a wire brush, check the nylon clamping jaw insert (
2
) and
replace if worn.
Clean the lock / un-lock mechanism of the clamping jaw
(
3
) and slightly lubricate it.
1105
Fig. 6.0-2
D.
Inspect and replace as necessary the plastic mount/
demount head insert. The insert is held in place by a small
roll pin. Drive the pin out with a punch, replace after new
insert is installed.
E.
Lubricate piston rods of turntable air cylinders with oil
as needed.
F.
Periodically wash all plastic parts with cold water
and soap or window cleaner (without alcohol neither
ammonia).
G.
Check the bead breaker pads. Replace if worn.
H.
Discharge water from air fi lter every day!! Do this by
turning the knob “
B
” clockwise and push upward. Water
will automatically be discharged. (see ‘
B
’ at Fig. 6.0-3).
EEWH326A Air-Electric Tire Changer