Page 16
NOTE
: The “P” button can be pressed as often as nec-
essary, with every press the machine updates the
memory of the valve position.
5. The machine displays "
SPN 2
". Lower the wheel
guard to spin the wheel, when the shaft reaches the
balancing speed, machine displays "
ACH 2
" along with
a beep.
6. Once the spin cycle is complete, the display reads
"
CAL CUL
" for one second. Machine calculates the
results based on the previous two spins.
From this point, there are three possible procedures to
conclude the match balance routine. These 3 proce-
dures are quite different depending on the results of
calculation.
Procedure 1
The imbalance measured in spin 2 has been reduced
to an acceptable amount, less than 2 oz, and it will not
be necessary to continue match balance. The display
reads "
ACH FIN
" for one second, and then proceeds
to the normal two-plane balancing mode and displays
the weight imbalance amount and its position for both
planes.
Procedure 2
Due to a large amount of remaining imbalance the op-
erator can continue match mount. Machine displays
"
CrS
” “
r
" and "tur” “tir" alternatively. This instructs the
operator to turn the wheel and make a double cross
mark (XX) on the right side of the tire at 12 o'clock posi-
tion when the right center position LED turns to green.
See Figure 29.
NOTE
: If you do not intend to continue minimization,
you can press the Cancel/Stop button
If the Cancel/Stop button is pressed now, machine dis-
plays "
Qit Qit
" for one and half second to remind op-
erator whether he wants to quit optimization or not. If
one presses Cancel/Stop button immediately, the pro-
gram goes to procedure 1. If not, after one and half
second, machine returns to the optimization procedure.
To continue with optimization: Deflate the tire and then
turn the valve to point the XX mark on the tire. Remount
tire/wheel onto shaft, press “P” when ready to continue.
1. The machine displays "
VAL tOP
". Turn the wheel
so the valve is at top position. (12 o'clock) and then
press P button. The machine stores the valve position.
See Figure 30.
2. The machine displays "
SPN 3
". Lower wheel guard
to spin shaft. Machine displays "
ACH 3
".
Figure 29
Figure 30
