6 • Snap-on
Brake Lathes
Installation
1.
Cut the straps securing the lathe to the shipping
pallet. Place the lathe on the bench.
2.
Position the lathe over the four (4) holes indicated
in Fig. 1. Use the four (4) pilot bolts and washers pro-
vided to fasten the lathe to the bench. Wrench tighten
the bolts.
3.
Before plugging the lathe in, be sure the on/off
toggle switch above the drum slide handwheel is in
the OFF position.
READ THE OILING INSTRUCTIONS BEFORE OPER-
ATING THE LATHE.
Figure 1
Electrical Wiring Requirements
The lathe should be electrically grounded to protect
the operator from shock. The lathe is equipped with an
approved 3-conductor cord and a 3-prong grounding
type plug to fit the proper grounding type receptacle.
If your lathe is for use on 115 volts, it has a plug and
outlet as illustrated in Fig. 2. Use only 3-wire exten-
sion cords which have 3-prong grounding type plugs
and 3-pole receptacles which accept the lathe’s plug.
230 volt lathes use a plug and outlet like those illus-
trated in Fig. 3.
Replace or repair damaged or worn cords immedi-
ately.
Figures 2 & 3
Operating Specifications
Overall Lathe Height . . . . . . . . . .14.25 in. (362 mm)
Spindle to Floor . . . . . . . . . . . . .39.25 in. (997 mm)
(when mounted on bench)
Spindle Speed . . . . . . . . . . . . . . . . . . . . . .125 RPM
Rotor Slide Feed Rate . . . ..0032 inch per revolution
(.0813 mm/rev.)
Drum Slide Feed Rate . . . ..0048 inch per revolution
(.1219 mm/rev.)
Micrometer Graduations . . . . . ..002 in. (.0508 mm)
Max. Brake Rotor Diameter . . . . . .15.75 in. (40 cm)
Max. Brake Rotor Thickness . . . . .1.75 in. (4.45 cm)
Min. Brake Drum Diameter . . . . . . .6 in. (15.25 cm)
Max. Brake Drum Diameter . . . . . .24 in. (60.96 cm)
Max. Drum Depth . . . . . . . . . . . . . .7 in. (17.78 cm)
Max. Load, 1 in. Arbor . . . . . . . . .100 lbs. (4536 Kg)
Max. Load, 1-7/8 in. Arbor . . . . . .200 lbs. (90.72 Kg)
Spindle Motor . . . . . . . . . . . . . . . . . . . . . . . . .1 HP
Electrical Requirements . . . . .115 VAC. 60 Hz, 1 Ph,
fused at 15 A
Lathe Weight . . . . . . . . . . . . . . . . .312 lbs. (141 Kg)
(lathe only)
Floor Space . . . . . . . . .34.75 in. wide x 48 in. deep
(822.65 mm x 1,219.22 mm)
(when mounted on bench)