SMSEagle NPE-9300-GPRS/3G, User Manual

Page: 101 / 107

Page
101
Restoring factory defaults
This action restores the following settings to default values: IP settings, database content.
In order to restore factory defaults proceed with the following steps:
LED signaling USER actions System reaction
When the device is
ready to operate:
When READY LED is
blinking and USER LED is
disabled (do not
proceed if you don’t
have that state!)
1. Press and hold SW
button for 10 seconds
Restore service is counting
down.
2. Release SW button
after 10 seconds.
User LED will begin to
blink.
System is reading factory
defaults.
Factory settings are being
applied to the device.
3. Wait until system
reboots.
Default IP settings are
restored. System is going for a reboot.
Please note, that after reboot the device will be finishing the process of factory reset, therefore it can take
longer for the system to start.