Summit Suite Owner Manual
9
•
Unthread the nutserts a bit (not
all the way) and then slide the
nutserts in the mounting channel
until the handle is located in
middle of the tent, underneath the
logo on the back of the tent.
•
Tighten.
•
Remove the latches from the
plastic packaging, and unhook
the bottom C brackets from each
latch. Remove the rods from these
lower C brackets by removing
the Allen head key bolts on both
sides. Put all the parts of the lower
brackets aside so you don’t mix
them up with the other parts.
•
Next you must take the apart the
latching mechanism from the
upper C bracket for installation.
Once disassembled, start with
upper portion C bracket.
A) Latches Centered on the back of
the Tent.
•
Locate the centre of the tent,
and approximately 8 inches from
centre should be the centre of
your C bracket - slide it in.
•
Tighten the bolts while applying
downward pressure (doing this
will make it easier for you to open
your latches, they can be hard to
open and close at first).
•
Reattach the latching mechanism
to the C bracket using the
hardware that you had removed
with a 10mm wrench and the
provided Allen key.
•
Next you will slide in the lower C
bracket (without the rod in) into
it’s approximate location. Flip the
latching mechanism down into
latch position, which will show you
the perfect location to tighten the
bolts on the lower bracket.
•
Tighten the bolts on the lower C
bracket while applying upward
pressure.
Install the Handle
Stainless Steel Latches
Installation:
A
B
C
Mounting Location A
Mounting Location B
Mounting Location C
BACK OF TENT
BACK OF TENT
BACK
FRONT
BACK
FRONT
RIGHT SIDE
LEFT SIDE
3
4
a