SMRT TENT SKY LOFT, Owner'S Manual

Page: 8 / 16

8
We recommend laying your new tent
on the top piece of the cardboard
box it came in to set it up!
•
Undo the two straps at the back
of the tent by depressing the
levers and pulling the straps out
the top. Once both straps are
undone, you can open the tent.
•
Pull down the bungee cord from
the middle of the tent and lower
it to the base
•
Flip the bottom tent flap down
around the base of the tent
•
Unzip the main door at the
back of the tent and remove all
contents from tent. You should
have 2 window rods in a bag, 2
shoe bags, a ladder bag, and an
install kit bag.
•
Unclip the buckles on the ladder
bag and find the install kit inside
the bag (beige pouch). Remove
the contents. You should find a
13mm ratchet wrench, 4 bottom
brackets wrapped in rubber, 8
sliders, and 8 nuts and bolts.
•
Take the nuts off the bolts and
put the bolts into the sliders, with
the head of the bolt sitting in the
channel, so the slider top remains
flush with the head of the bolt. Set
aside. (Figure A)
•
Undo the knot in the upper strap
at the back of the tent. You will
use this strap to pull down and
close your tent while in use.
•
Unzip the side windows and fold
them into the tent to create an
opening for air to flow out.
•
Push down evenly on the tent to
somewhat close it back up and
reattach the straps. Note: This
can be a loose close, you don’t
have to have your fabric tucked in;
we usually leave ours open with
3-4 inches of space. This partial
closing is only to make the lifting
of the tent easier.
1 2
Open the tent and remove the
contents for install.
Prep the tent to be installed on
your vehicle.
A
B
C