Step 3:
Locate
Tools Needed
Procedure
Note
: Burner Chamber Assembly [3], Three M6x10mm
Bolts [13A], Match Stick Holder [13K]
: Phillips head screwdriver
Note: Inspect the burner chamber prior to assembly to
make certain the burner tube is
correctly over the end
of the valve
as shown:
:
Align the burner chamber assembly [3] underneath the
smoker as shown.
Place the body of the burner chamber assembly so that it
sits flush with the bottom of the cabinet. The mounting
holes and mounting tabs should line up.
For each mounting hole, insert a M6x10mm bolt [13A].
Attach the Match Stick Holder [13K] to one of the front
bolts as shown.
Securely tighten all three bolts.
: The match stick holder [13K] is used to hold a
match when match lighting the smoker. Refer to page 16
for lighting procedures. The match stick holder simply
rests in the bottom of the smoker when not in use.
Securely tighten all three bolts.
Step 4:
Locate
Tools Needed
Procedure
: Zip Tie [13F]
: None
:
Loop the zip tie [13F] through the outside hole of the
front smoker leg [4] as shown.
Capture the gas hose with the zip tie to secure it. Do not
pull the zip tie too tight - it may restrict gas flow through
the hose.
3
Assembly
Assembly
7
3
4
13F
13A
13K
13A
13A
