11
Using the Power Pack or AC Adapter
Depending on your delivery, your clinician may give you a
rechargeable Power Pack or an AC Adapter to power your
pump. For complete instructions, you should also read the
Instructions for Use
that come with the Power Pack or AC
Adapter.
The cord from the Power Pack or AC Adapter plugs directly
into the “Power” jack on the side of your pump.
NOTE:
A good 9 volt battery must also be installed in your
pump as a backup. Otherwise, you won’t be able to start the
pump. Your Power Pack or AC Adapter may or may not have
the connector shown.
1. Open the “Power” cover
on the side of your pump.
2. Line up the red mark on
the Power Pack cord
connector with the red
mark on the pump’s
Power jack.
3. Push the connector
forward until it stops. Do
not twist or turn the
connector. Pull lightly on
the cord directly behind
the flared part of the
connector to make sure it is firmly attached.
CAUTION: Failure to push the connector all the way forward
may result in an intermittent connection, and the connector
may dislodge, causing a loss of power.
Power Jack
Red Mark
