8
Introduction
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
SETUP ASSEMBLY
B
ATTERY BOX
1. Battery box is mounted on the left hand side of the roll bar.
2. Measure up 5
1
/
2
" from the roll bar mounting plate.
3. Use a u-bolt from the small parts bag to hold the battery box in
place. Tighten all hardware
4. Battery not furnished. Install an automotive type SP 375 cold
cranking amps (minimum) battery in the battery box of the
Sand Star Zee. This is a negative grounding system. Attach
the rubber battery (C) hold-down found in the small parts bag.
Then attach red positive (+) cable (A) to positive terminal. Slide
rubber boot over the positive terminal to prevent shorts. Attach
black negative (-) cable (B) to the negative terminal.
Connecting battery cables to the
wrong post could result in personal injury and/
or damage to the electrical system. Make sure
battery and cables do not interfere or rub on any
moving part. Connect the red positive (+) cable
(A) to the battery first. When disconnecting remove the black
negative (-) cable (B) first.
FUEL , HYDRAULIC OIL AND GREASE FITTINGS
1. Check engine oil and add as necessary. See engine manual for recom-
mended motor oil.
DO NOT OVERFILL
.
2. Fill Gas Tanks with Unleaded 87 Octane gasoline (minimum).When filling
the fuel tank stop when the fuel reaches 1 inch (2.54cm) from the top.
This space is necessary for fuel expansion.
DO NOT OVERFILL.
Fuel is flammable. Caution must be used when storing or handling it. Do not fill fuel
tank while engine is operating or in an enclosed area. Fumes are explosive and dan-
gerous to inhale. DO NOT SMOKE while filling the fuel tank. DO NOT OVERFILL.
The engine and exhaust system become very hot during operation. Rick of burns if
touched. Allow engine and exhaust system to cool before refueling.
3.
Check hydraulic oil level in the tank reservoir. The level should be
1-3" from
the bottom of the dipstick. If level is low add
Parker Dura Clean Hydraulic Oil or equivalent of
AW32 minimum hydraulic oil.
4. Machine should be greased before starting. Use
general purpose No. 2 lithium base grease.
A. Rear attachment lift yoke.
B. Right attachment lift mount.
C. Left attachment lift mount.
D. Center attachment lift yoke.
E. Center lift lever.
F. Front fork.
5. Read operating instructions before starting ma-
chine.
