SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
FS300
VERSION 8/2013
Gas
SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
MAINTENANCE CHECK LIST
Note:
Make sure the ignition is in the
OFF
position, and the spark plug is disconnected
before servicing
• Maintain proper engine oil and crankcase
levels.
Change every 25-50 hours
(see Honda manual).
• Clean spark plugs regularly, and set the
proper gap.
• Wash the air cleaner element in a non oil-
based solvent, then squeeze out residue.
Allow filter to dry before reinstalling in cleaner.
• Keep a coating of grease on the drive shaft
and threads for easy installation or removal,
and for longer hex bushing life.
• Check all fasteners and re-tighten, since the
machine will vibrate the fasteners loose if they
are not secured. Use locktight.
• Check the Drive belt for wear, and adjust
(tension), or replace as required.
After replacing belts, check for proper tension:
• Adjust Idler to tension belt. Do not over
tighten.
• Check that the pulleys are aligned properly
to ensure the belts are running true.
10
• The inside housing must be clean, and
remove any build-up from inside the cage so
cutters and drum rotate freely.
• Inspect and change drum bushings and
shafts every 40 hours, or when worn.
