AirVerter
®
Stencil Pro HVLP Paint Spray System
DO NOT OPERATE SPRAY GUNS WITHOUT PERSONAL SAFETY EQUIPMENT
Stencil Pro Troubleshooting Guide
Trouble
Probable Cause
Remedy
Paint Will Not
Flow
1. Blockage in fluid nozzle
2. Loose fluid nozzle
3. Coating is too thick
4. Loose needle packing
1. Clean or replace; strain paint
2. Tighten
3. Thin the coating
4. Adjust packing
Inconsistent
Spray Pattern
(Spits and
Sputters)
1. Running out of paint
2. Loose needle packing
1. Fill cup or pot, but never the top ¼
2. Adjust packing
Leakage at
Front of Gun
1. Damaged fluid needle
2. Wrong size fluid needle
3. Dirty fluid nozzle
4. Impurities in paint
5. Loose fluid nozzle
6. Fluid adjustment screwed all
the way out
7. Needle not firmly seated in
the nozzle
8. Packing too tight
1. Replace
2. Replace
3. Clean
4. Strain paint
5. Tighten
6. Rotate Fluid Control Knob (CT-05-1)
on rear of gun clockwise
7. Check for nozzle obstruction
8. Loosen and adjust to correct tension
Distorted
Spray Pattern
1. Dirty or damaged air cap
2. Dirty or damaged fluid nozzle
or needle
3. Fluid nozzle partially clogged
4. Fluid nozzle not centered with
air cap
5. Air cap not seated correctly
1. Clean or replace
2. Clean or replace
3. Clean
4. Replace air cap
5. Re-seat air cap
Summary of Contents for AirVerter Stencil Pro CT-100
Page 12: ......
