•
Do NOT plug the unit into an electric socket until the softbox is
fully assembled and LED bulbs are in place. Failure to observe
this warning could result in electric shock, injury or even death.
•
Appliance must only be used with rated voltage and frequency
of 100-250V 50/60Hz.
•
Avoid unplugging the power by pulling the power cord. Do not
touch the power cord with wet hands.
•
Never attempt to insert any metal objects into the cooling slots
of the lamp.
•
Avoid moving the softbox and stand by pulling the power
cable.
•
Stop usage if the unit has been damaged, especially to the
power cord or socket.
•
Do not expose to moisture.
•
Indoor use only.
•
In the event service is needed, contact Smith-Victor.
Set Up of the Kit Components
1
- To open BellaBox, use
the floor as a support.
2
- Center the “O” ring
over the bulb socket.
3
- Push down until ring locks in
place. When “O” ring snaps
into place, secure the softbox
to the stand by tightening the
thumb screw on the stand
mount until it is firmly attached
to the stand.
4
- Mount softbox on stand
and screw in LED bulb. Be
careful not to cross thread the
lamp and the socket.
5
- Attach front diffusion panel by
sliding black edge of the panel
over the outside edge of the
softbox until it is secured on all
sides. Adjust angle as desired by
loosening and tightening the
thumbscrew at the base of the
softbox.
Kit includes
:
(2) Quick-Folding 20” x 20” Softboxes
(2) Sockets with Power Cords
(2) LED 60W Bulb (500W equivalent each)
(2) Diffusers
(2) 6’ Light Stands
(1) Padded Carry/Storage Case
SAFETY WARNING PRECAUTIONS:
Two Light Kit
Model: BellaBox 1000
Item: 401377
What’s in the Box
