S E C T I O N 4
•
A s s e m b l y I n s t r u c t i o n s
HOTLINE
®
3 Blood and Fluid Warmer | Operator’s Manual
9
SECTION 4
Assembly Instructions
Read through the instructions completely prior to setting up the
HOTLINE
3 Warmer.
Step 1 - Unpack the HOTLINE
3 Warmer
1
Open the shipping carton and remove the
HOTLINE
3
Warmer.
2
Check the contents of the package to verify the following
components are present:
• HOTLINE
3 Warmer
• Operator’s Manual
• HOTLINE
3 Inspection/Test Form
3
Examine the
HOTLINE
3
Warmer for damage. If any components
appear damaged, do not use the
HOTLINE
3
Warmer. Contact
Smiths Medical for a replacement.
Note: After unpacking the
HOTLINE
3 Warmer, recycle packaging
material according to hospital policy for recyclable materials.
Step 2 - Clamp the HOTLINE
3
Warmer to the I.V.
Pole
WARNINGS
WARNINGS
• Ensure that the HOTLINE
®
3 Warmer pole clamp is screwed
tightly onto the I.V. pole. Failure to securely mount the
HOTLINE
®
3 Warmer onto the I.V. pole may cause the
HOTLINE
®
3 Warmer to slide down the pole and may injure the
patient or user.
• Do not mount the HOTLINE
®
3 Warmer more than 107cm (42”)
above the floor. For convenience, 107cm (42") is indicated on
the HOTLINE
®
3
Warmer line cord by a black mark. Mounting
the HOTLINE
®
3 Warmer above 107cm (42”) may result in
instability of the pole and tipping that may injure the patient or
user.
CAUTIONS
• This device is cooled by convection. Be sure the air vents on the
bottom and the back of the device are kept clear.
