5
6
smithandnoble .com
800 .248 .8888
STEP 2 - MOUNTING THE BRACKETS
Inside Mount
STEP 1:
Place the panel on the rod. To ensure it
drapes at the correct length, hold it up
to the spot you wish to install it. Raise or
lower your treatment as desired. After
you’ve located the ideal location, use a
pencil to mark where the top of the rod
is resting.
STEP 2:
Using a pencil, mark the position on
both sides of the window frame where
the brackets will be attached.
STEP 3:
Make sure the brackets are aligned
and level with one another.
STEP 4:
Position the inside mounting bracket
with the openface end facing upward,
and the set screw in the back. Attach it
with the screws provided.
ROD
INSIDE
MOUNTING BRACKET
INSIDE
MOUNTING BRACKET
INSIDE MOUNTING BRACKET
Adding or Removing
Carriers to the Rod
Your track rod will come with all master
carriers and regular carriers pre-
installed . If you need to add or take out
some carriers to refl ect same amount
of carriers to pin hooks in your drapery,
unscrew the fi nial from the rod.
Placing End Stops on the
Rod
Once all carriers have been placed in
the track, for
split drapery
(A), place
end stop click in between the fi rst
carrier from each end and the second
carrier so end of drape does not move
when drape is closed .
For
one way draw drapery
(B), place
end stop click in between the fi rst
carrier from the end and the second
carrier of the side you won’t be
opening it from so the end of drape
does not move when drape is closed .
STEP 3 - PLACING CARRIES & END STOPS
END STOP
END STOP
MASTER
CARRIERS
(B) One Way Draw
End stop & Carrier
positions
CARRIERS
ADD OR
REMOVE
CARRIERS
TRACK
END STOP
(A) Split Draw
End stop & Carrier
positions
CARRIERS
