IR lamp control module - HELCON 11XX series -
Installation, use and maintenance manual - EN
Ver. 1.02
12
5 Installation and commissioning
5.1 Preliminary operations
Before putting the device into service, check the following:
• verify the perfect integrity of the unit and its components
• check that all the documentation necessary for the installation is present
• read and understand the following manual in its entirety
During the installation of the HELCON module, it is necessary to avoid falls and violent im-
pacts which could compromise its regular operation.
Avoid directly touching the input/output connectors located on the underside of the HEL-
CON module unless you are equipped with suitable protective equipment for static electric-
ity; any discharges on the connectors could in fact damage the device.
Always make all electrical connections with the equipment off: this will avoid damage to the
computer and danger to the operator.
Use suitable tools when assembling the equipment, to avoid the risk of injury, crushing,
abrasion, etc...
The metal parts and all the "live" parts can under certain conditions cause cuts and tears.
Pay particular attention in case of contact and use suitable personal protective equipment
(PPE).
Do not position the device in such a way that it is difficult to disconnect the wiring connected
to it.
