Smeg WDI14C7-2, Instruction Manual

Page: 12 / 78

EN
11
2.5 ELECTRICAL CONNECTION
Before connecting the plug to the power socket ensure that:
1. The electrical system voltage is the same as that stated on the nameplate
on the front of the appliance, in the zone visible when the door is open.
The rated power supply and the fuses required are specified on the name-
plate.
2. The meter, safety breakers, power supply line and power socket are rated
to withstand the maximum load required, stated on the nameplate.
3. The power supply socket and the plug fitted to the appliance are compat-
ible without the use of reductions, multiple sockets, adapters and exten-
sion leads which might cause overheating or scorching.
If the power supply socket is not compatible with the plug supplied, re-
place the socket with one of the appropriate type.
Warning

The power plug must be accessible after the appliance has been installed.

It is absolutely essential to connect the appliance to earth. Connect
the plug to a socket with an earth connection in good working order.
The manufacturer declines all liability for direct or indirect injury or dam-
age deriving from a non-existent or defective earth connection. Correct
electrical connection guarantees conditions of maximum safety.

This appliance is compliant with the requirements of EEC directive 89/336
of 3.5.89 (including the amendment directive 92/31/EEC) concerning the
elimination of radio-frequency disturbance.

If the power supply lead is damaged, it must only be replaced with an orig-
inal spare, available from the After-Sales Service.

Do not connection/disconnect the power supply plug from the socket
with wet hands

Only disconnect the power supply plug from the socket by taking
hold of the plug itself, never by pulling on the lead.