![Smeg UKC4172F User Manual Download Page 18](http://html1.mh-extra.com/html/smeg/ukc4172f/ukc4172f_user-manual_1304111018.webp)
Problem
Possible cause
Solution
Stored food was not wrap‐
ped.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Water flows inside the refrig‐
erator.
Food products prevent the
water from flowing into the
water collector.
Make sure that food prod‐
ucts do not touch the rear
plate.
The water outlet is clogged.
Clean the water outlet.
Water flows on the floor.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be set.
The "FastFreeze function" is
switched on.
Switch off "FastFreeze func‐
tion" manually, or wait until
the function deactivates au‐
tomatically to set the tem‐
perature. Refer to "Fast‐
Freeze function" section.
The temperature in the ap‐
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The food products' tempera‐
ture is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if neces‐
sary.
The FastFreeze function is
switched on.
Refer to "FastFreeze func‐
tion" section.
There is no cold air circula‐
tion in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
Some specific surfaces in‐
side the fridge compartment
are warmer at some times.
This is a normal state.
37