Smeg UD515D, Translation Of The Original Instructions

Page: 31 / 39

31
10 CHOSING THE PROGRAM
When you scroll through the available programs, the program number (P1, P2, .... etc.) and its
duration are shown first, alternating with the wash and rinse temperatures.
PROGRAM TYPE OF DIRT DURATION (*)
DISHES Short P1 Lightly soiled plates 1 min
CUPS P2 Large and small cups 1 min 30 s
DISHES L (long) P3 Heavily soiled plates 3 min 00s
POTS P4 Pots and pans 4 min 10s
GLASS M (medium) P5 Normailly soiled glasses 1 min 20s
GLASS L (long) P6 Heavily soiled glasses 2 min 10s
USER PR P7 Customisable (see "set-up information") 1- 10 min
(*) The cycle duration stated above is guaranteed if the water intake temperature is as stated and
recommended in the "TECHNICAL DATA" table, and in all cases refers to the first cycle performed.
For repeated cycles, operating conditions may vary from installation to installation. If the
dishwasher is supplied with cold water, the cycle duration might increase depending on the intake
water temperature and the "thermostop" setting.
Power blackouts.
If the dishwasher is open when power is restored, the display will read “
° t
” and the
heating element will remain off, to prevent the risk of burns to the user.
Close the dishwasher to resume heating the water in the tank.
ENABLING/DISABLING THE PROGRAM NAME ON THE DISPLAY
By default, the display shows the program number P1, P2, P3, and its duration, alternating with
the wash and rinse temperatures. It is also possible to display the name of the program. In this
case, the name of the program will be displayed first and the progressive program number and the
duration will be displayed on the following screen e.g. Glass >>> P1 1:10.
The procedure must be carried out with the machine switched off but powered.
Press and hold down the start / pause button.
When the horizontal lines - - - - - appear on the display, release the start / pause button and then
press it again immediately.
The procedure is complete; there is no audible or visual confirmation.
It is possible to check if the procedure has been carried out correctly when the machine is
switched on again.