GB
3. INSTALLATION INSTRUCTIONS
Important !
The appliance must be installed by a specialised technician according to current regulations.
This washer dryer is very heavy. Take care when lifting it.
3.1 UNPACKING
The inside of the machine comprises a moving assembly which is blocked for transport purposes by the screws
(
A)
located at the rear of the washer dryer.
1. Release the assembly by removing these screws with a 13 mm wrench.
2. Remove the screws (
A)
and relative plastic spacers (
B)
from the back of the washer dryer.
3. To prevent water from entering the machine or people from touching live components with their fingers,
close
the four holes left open by the screws with the supplied plastic plugs (C).
Attention!
•
Do not turn the machine upside down and do not place it on its side.
•
Keep all the components used to block the drum assembly as they will be needed if you decide to move the
appliance in future.
3.2 REMOVING THE WOODEN BASE
1. Place the white polystyrene corner pieces on the floor, approximately 50
centimetres behind the machine, as shown in the diagram.
2. Carefully place the machine on the
corner pieces.
3. Remove the four screws fixing the wooden base with a 10mm wrench.
6
