User instructions
16
ENERSAVE
Only
at the end of the
Eco program
will Enersave be activated, which
further
reduce energy consumption
. At the end of the washing, an
automatic device releases the door, which opens slowly a few inches. This
allows optimal drying, even at low rinsing temperatures, allowing
significant energy savings.
Once the door has opened, the end of the wash
cycle is indicated by a short beep.
Do not leave
anything in the space in front of the door necessary to allow
it to open.
Do not re-close the door during automatic opening
as this would
damage the mechanism. Wait for the pushers to retract before re-closing
the door.
NOTES AND REFERENCES
Only
run the soak program with half loads.
Options
cannot
be used with the soak program.
*
Standard programme under
EN 50242
.
**
See information sheet provided
***
IEC/DIN
reference programme.
**** Reference program for laboratories: Detergent:
20g
in the
dispenser
+
10g
in
the
door
or tablet.
Configuration
: see photo in “Using the baskets”.
(1)
Program consumption and duration figures have been measured in accordance
with the
EN 50242
standard. Values may vary depending on intake water and
room temperatures and the type and quantity of dishes loaded.
(2)
1 or 2 cold rinses depending on the model.
REFERENCES
for the
ENERGY LABEL
supplied with the dishwasher:
-
Annual energy consumption is based on
280 standard wash cycles
with cold
water and consumption of low-energy operating modes. Actual consumption
depends on the way in which the appliance is used.
-
Water consumption is based on
280 standard wash cycles
. Actual
consumption depends on the way in which the appliance is used.
-
Information refers to the
EN 50242 STANDARD
programme (identified in the
programmes table), which is the most effective in terms of combined energy
and water consumption. The programme is recommended for dishes with a
normal level of dirt.
-
Drying efficiency class on a scale from
“G”
(minimum efficiency) to
“A”
(maximum efficiency).
Summary of Contents for STP522
Page 2: ......