USER INSTRUCTIONS
19
EN
20
USER INSTRUCTIONS
EN
EN
16
USER INSTRUCTION
5
OPERATING INSTRUCTIONS
BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU HAVE
READ AND UNDERSTOOD ALL THE WARNINGS CONTAINED IN CHAP-
TER 2 “IMPORTANT SAFETY INSTRUCTION”.
Once the dishwasher has been correctly installed, prepare for use as follows:
•
add the rinse-aid and detergent.
5.2
Using the rinse-aid and detergent dispensers
The detergent and rinse aid dispensers are situated on the inner part of the door:
the detergent dispenser (ref. A fig. 5-03) is on the left, and the rinse-aid
dispenser (ref. B fig. 5-03) is on the right.
A
B
WITH THE EXCEPTION OF THE
SOAK
PROGRAM, BEFORE EVERY
WASHING CYCLE IT IS NECESSARY TO ADD THE REQUIRED AMOUNT
OF DETERGENT TO THE
DETERGENT DISPENSER
. THE RINSE AID,
ON THE OTHER HAND, SHOULD ONLY BE ADDED AS REQUIRED.
Fig. 5-03
•
adjust the water softening system;
•
add the regenerating salt;
EN
17
USER INSTRUCTIONS
5.2.1 Adding the rinse-aid
The rinse aid helps the dishes dry faster and prevents the formation of scale deposits
and staining; it is automatically added to the water during the final rinse cycle, from
the container situated on the inner side of the door.
A
C
B
To add rinse aid:
• Open the door.
• Rotate the container cover (ref. A fig. 5-04) anticlockwise by ¼ of a turn and re-
move it.
• Add the rinse aid until the container is full (approximately 140 ml). The optical
level indicator (ref. B fig. 5-04), on the side of the cap should be completely ob-
scured. Refill the rinse aid when the optical level indicator becomes clear again,
or when the rinse aid warning light illuminates (see “Description of controls”
manual).
• Replace the cover (ref. A fig. 5-04) by turning it in a clockwise direction until it is
fully closed.
• Use a cloth to remove any spillage of rinse aid which might lead to the formation
of excess foam.
5.2.2 Adjusting the rinse-aid dispenser setting
The rinse-aid dispenser can be set to one of 6 different levels. The dishwasher is
factory set for medium water hardness (selector set to “3”). To change the setting,
turn the dispenser selector (ref. c fig. 5-04) to the desired position: the amount of
rinse-aid dispensed is proportional to the position of this selector. Make sure that
the minimum amount of rinse-aid (selector turned to “1”) is approximately 1 ml and
the maximum amount (selector turned to “6”) is approximately 6 ml.
Fig. 5-04
