Smeg ST2FABCR, Instruction Manual

Page: 9 / 33

User instructions
7
1.2 Washing programs
Before starting a washing program make sure that:
 The water supply tap is open.

The correct amount of detergent has been added to the
dispenser.

The baskets have been correctly loaded.
 The spray arms are able to rotate freely and without
obstruction.
 The dishwasher door is securely closed.
Warning :
during the initial phase of the washing program, the operation of sprayers
is not perceived because they start rotating about 5 minutes after the start.
This is the normal operation of the washing cycle.
QUICK TIME PROGRAMS
Select this option together with any washing program (except the soak program) to
SHORTEN the cycle by from a minimum of 10% to a maximum of 55%, depending
on the cycle selected. To activate this option, press the QUICK OPTION button
(light comes on) after selecting the program required. The option is automatically
deactivated at the end of the program.
ENERSAVE
This option allows the further reduction of energy consumption, thanks
to the assisted drying when the door opens at the end of the cycle. At the
end of the wash, a device automatically releases the door, which slowly
opens a few centimeters. This allows the best drying possible, even at low
rinse temperature, permitting an important
energy saving .
When the door is completely open, a brief sound signal indicates that the
wash cycle has ended.
Enersave is automatically activated in all programs that include a final
drying phase (see program table). It is possible to disable it before starting
the program.
If this function is active, never prevent the door from opening by any
means, clear the space necessary to allow the opening of the door. Do
not force the closure of the door before the end of cycle signal, because
this would damage the mechanism.