Instructions for the installer
24
2.
POSITIONING THE HOB
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
Never use silicone or other insulating products when installing the
appliance; use only the rubber gasket provided.
2.1.1
Attachment to support structure
Create an opening with the dimensions shown in the figure in the top
surface of the counter, keeping a minimum distance of
50 mm
from the
rear border.
This appliance can therefore be mounted against walls higher than the
work surface on condition that a certain distance be kept between the
appliance and the wall as shown in the figure so as to avoid damage from
overheating.
Make sure there is a minimum of
750 mm
between the hot plate flames
and any shelf that may be installed directly above them.
A (mm)
B (mm)
C (mm)
D (mm)
E (mm)
L (mm)
X (mm)
Y (mm)
min 110
min 460
min 750
20÷40
min 50
600
555÷560
478÷482
