Installation
62
Fixed connection
Fit the power line with an all-pole circuit
breaker in compliance with installation
regulations. The circuit breaker should be
located near the appliance and in an easily
reachable position.
Testing
At the end of installation, carry out a brief
inspection test. If the hob fails to operate,
after checking that you have carried out the
instructions correctly, unplug the appliance
and contact Technical Support.
5.2 Instructions for the installer
• Do not bend or trap the power cable.
• The appliance must be installed
according to the installation diagrams.
• If the appliance does not work correctly
after having carried out all the checks,
contact your local Authorised Service
Centre.
• Once the appliance has been installed,
please explain to the user how to use it
correctly.
5.3 Power control menu (for installer
only)
The power control menu allows you to set
the maximum power supplied by the
appliance. Complete the following within 2
minutes of switching off the appliance:
1. Press and hold the
and
buttons until you hear the buzzer.
2. Press the middle of the two scroll bars of
the right zones until you hear the buzzer.
3. The timer display shows
.
4. Use the left-hand scroll bar to increase or
decrease the power level (associated
with a progressive number, shown in the
number icon).
5. Press and hold the
button to save
the modifications.
6. Press and hold the
button to discard
the modifications.
Power level table
.
Run the power cable in the rear
part of the unit. Make sure that it
does not come into contact with
the lower part of the hob or a built-
in oven below it.
Be careful when connecting
additional electrical appliances.
Connection cables must not come
into contact with hot cooking
zones.
Mod. 90 cm
Level 0 (
P0
- default)
11050 W
Level 1 (
P1
)
6000 W
Level 2 (
P2
)
5000 W
Level 3 (
P3
)
4200 W
