EN
13
4
4 / SPECIAL MESSAGES, DIFFICULTIES
Warning
In the event that there is a break, crack or opening--even minor--in the vitroceramic
glass, immediately disconnect your appliance to avoid the risk of electric shock.
Contact the After-Sales Service Department.
YOU OBSERVE THAT:
POSSIBLE CAUSES:
WHAT SHOULD YOU DO:
An indicator light appears.
Your installation blows a fuse.
Only one side works.
The hob produces an odour
during the first cooking ses-
sions.
Working normally.
The electrical hook-up of your
hob is incorrect.
New appliance.
Nothing.
Verify the connections.
See the "Hook-Up" sec-
tion.
Operate each cooking
zone for 30 minutes with a
saucepan full of water.
The hob stops working and it
emits a beep approximately
every 10 seconds and a
or
"F7" is displayed.
A series of small
or "F7" is
displayed.
After turning on a heating zone,
the indicator lights on the
control panel continue to flash.
The saucepans make noise
during cooking.
Your hob makes a clicking
sound during cooking.
The fan continues to function a
few minutes after your hob is
turned off.
There was an overflow or an
object is in contact with the
control panel.
The electronic boards heated
up.
The cookware used is not sui-
table for induction or is less
than 12 cm in diameter (10 cm
for the 16-cm cooking zone).
This is normal with some types
of cookware. This is caused by
the transfer of energy from the
hob to the cookware.
Cooling of the electronic com-
ponents.
Working normally.
Clean the hob or remove
the object, then begin
cooking again.
See "Built-In" section.
See section on cookware
for induction.
Nothing. There is no risk,
neither to your hob nor to
your cookware.
Nothing.
•
During operation
•
During initial use
YOU OBSERVE THAT:
POSSIBLE CAUSES:
WHAT SHOULD YOU DO:
The hob is not working and the
indicator lights on the control
panel are not on.
The table is not working and
another message is displayed.
The hob does not function, the
information
is displayed.
The appliance is not receiving
electricity. The electrical sup-
ply is defective or the hook-up
is incorrect.
The electronic board is func-
tioning poorly.
The hob is locked.
Inspect the electrical cir-
cuit breaker and fuses.
Call the After-Sales
Service Department.
See chapter on using the
child safety system.
•
When powering on
YOU OBSERVE THAT:
POSSIBLE CAUSES:
WHAT SHOULD YOU DO:
