EN
8
8
USE
L
T1
T2
T3
T4
L1
L2
L3
L4
Control panel
Button Function
Led
L
Turns the lighting system on and off.
-
Press and hold for approx. 2 seconds to turn
the lighting system on and off at reduced
intensity.
-
T1
Turn the suction motor on and off at speed
one.
On.
Press and hold the button for approximately
2 seconds, with all the loads turned off
(Motor and Lights), to reset the Filters and
turn off the Leds that are lit.
After 100 working hours all the LEDs (L1-
L2-L3-L4) will light up and remain lit to
indicate saturation of the metal grease filters.
After 200 working hours all the LEDs (L1-
L2-L3-L4) will light up and start to flash to
indicate saturation of the activated charcoal
filters.
T2
Turn the suction motor on at speed two.
On.
Press and hold for approximately 5 seconds,
with all the loads turned off (Motor and
Lights), to enable/disable the Remote
control.
2 flashes, Remote control Enabled.
1 flash, Remote control Disabled.
T3
Turn the suction motor on at speed three.
On.
Press and hold the button for 2 seconds to
activate intensive speed. This speed is timed
to run for 10 minutes. At the end of this
time the system will automatically return to
the speed set before.
T4
Press and hold the button for approximately
2 seconds to activate automatic shutdown
with a 30' delay (Motor+Lights).
On.
Press and hold for approximately 5 seconds
to enable/disable the Activated Charcoal
Filter alarm.
2 Flashes of the Leds (L1-L2-L3) Filter
Alarm Enabled.
1 Flash of the Leds (L1-L2-L3) Filter Alarm
Disabled.