Instructions for the installer
9
4
GAS CONNECTION
Connection to the gas mains may be made with a
rigid copper
pipe
or with a
flexible pipe
and conforming to the provisions defined by
standard regulations in force.
To facilitate connection, fitting
A
on the rear of the appliance may be
adjusted laterally. For this purpose, loosen hexagon nut
B
, turn fitting
A
to the desired position, and retighten hexagon nut
B
(tightness is
ensured by a biconical brass ring). Use a soapy solution to check for
proper tightness. Never use a free flame. The hob has been inspected
for
G20
(2H) natural gas at a pressure of 20 mbar. For use with other
types of gases, see Section “ ADAPTATION TO DIFFERENT TYPES
OF GAS”. The gas intake fitting is ½” gas external threaded.
Connection with rigid copper pipe:
the
connection to the gas mains must not
provoke stress of any kind on the hob.
Connection may be made by using
biconical adapter
D
with insertion of gasket
C
(supplied).
Connection with flexible pipe:
use only
flexible pipes conforming to standard
regulations in force, inserting gasket
C
(supplied) between fitting
A
and flexible
pipe
E
.
The flexible pipe has to be installed so that pipe length does not
exceed 2 meters of maximum extension. Make sure that the pipes do
not touch any moving parts or become damaged.
Summary of Contents for SER63LPG
Page 20: ......
