EN
28
7KHJOXHVXVHGLQPDQXIDFWXULQJWKHNLWFKHQXQLW
DQGLQWKHDGKHVLYHRQWKHGHFRUDWLYHODPLQDWHRIWKH
ZRUNWRSVXUIDFHVKRXOGEHPDGHWRWROHUDWHWHPSHUD
-
WXUHVRIXSWR&
SMEG assumes no responsibility for any malfunc-
tion or damage caused by faulty installation.
PLEASE REMEMBER THAT THE GUA RANTEE DOES
NOT COVER THE GLASS IF IT SUFFERS A VIOLENT
BLOW OR IF IT IS USED IMPROPERLY.
)DVWHULQJWKHKRE
When the gap has been properly sized, the sealing washer
should be put on the lower face of the glass. Silicone should
not be applied between the glass and the unit worktop
because if it becomes necessary to remove the hob from
its position, the glass could break when trying to detach it.
To secure the hob to the cabinet, four brackets should be
fastened to the existing hole son the bottom part of the
casing (two in the front and two in the back). There are two
possibilities of where the brackets may be placed, just as
LVVKRZQLQ¿JXUH
¿J
Sealing washer
Sealing washer
Depending on the thickness of the cabinet, it may be nec-
essary to use the self tapping screws that are provided as
compliments for securing; insert them in the circular holes
of the bracket. The thread of this hole will be made when
the screw is inserted inside of it. The thread should be made
before fastening the bracket to the hob.
&RQQHFWLQJWKHHOHFWULFLW\
The electric connection is made via an omnipolar switch
or plug where accessible, which is suitable for the intensity
to be tolerated and which has a minimum gap of 3 mm
between its contacts, which will ensure disconnection in
case of emergency or when cleaning the hob.
The connection should include correct earthing, in compli-
ance with current norms.
,IWKHÀH[LEOHVXSSO\FDEOH¿WWHGWRWKHVHDSSOLDQFHVHYHU
needs to be changed, it should be replaced by SMEG’s
RႈFLDOVHUYLFH
The input cable should not be in contact either with the
body of the hob or with the body of the oven, if the oven is
installed in the same unit.
Summary of Contents for SE232TD1
Page 1: ... 6 37 1 5 69 12 52 1 6 7 ...
Page 2: ......
