Smeg SAWD612, Instructions For Use Manual

Page: 12 / 20

12
SM2831
USE OF THE WASHING MACHINE
VARIABLE SPIN:
DELAYED START BUTTON:
START BUTTON:
After having carried out all the operations described in points 1 to 8 in the paragra-
ph “WASHING CYCLE” press this button and the washing machine will begin its
washing cycle.
The relative LED will light up after 2-3 seconds, to indicate that the door is locked
and the program has started.
GB
The washing machine is equipped with a function that allows the start of the wash
to be delayed for up to a maximum of 8 hours. The delay time is selected as follows:
each time button (I) is pressed, the wash will be delayed by 1, 2, 4, 8 hours. Once
start button (L) has been pressed, either the selected led or button (I) will fl ash
(according to the model) to indicate that the function has been enabled.
The washing machine will now automatically start the wash cycle after having waited
for the number of hours set.
(This function is also useful for users with off-peak electricity).
The function of stop is to reset the washing machine.
If for any reason during the washing cycle you decide to vary it, or decide later to
add more laundry, all you have to do is turn the knob of the program selector to
the “STOP” position, then reset the knob to the new program chosen and press the
“START” button.
“STOP” ON THE PROGRAM SELECTOR:
The machine offers a wide choice of spin settings that can be selected before star-
ting the program.
To vary the spin setting just press button (H) until the desired value is reached (fi g. 1);
if you wish to exclude the spin, press the button until “0” appears on the display (fi g. 2).
Out of balance spin protection for the load:
This washing machine is equipped with a special electronic control system for the correct balancing
of the load. Before each spin, the system makes the clothes arrange themselves in the drum in the
most even way possible.
In case of irregular distribution of the laundry, for safety reasons the spin speed is reduced and in
cases of the load being greatly out of balance, the spin cycle will not be effected.
Warning!! It is recommended to use this function only if strictly necessary and solely if the
program to be reset has started not more than 3 minutes previously.
Before being able to open the door after a reset, you must wait 2 minutes for it to be unlocked.
N.B. The maximum spin speed varies according to the model and is shown on the machine
display.
The maximum spin speed that can be selected decreases with the program that is set.