Installation
32
Fixed connection
Fit the power line with an all-pole circuit
breaker in compliance with installation
regulations. The circuit breaker should be
located near the appliance and in an easily
reachable position.
Testing
At the end of installation, carry out a brief
inspection test. If the hob fails to operate,
after checking that you have carried out the
instructions correctly, unplug the appliance
and contact Technical Support.
5.2 Instructions for the installer
• Do not bend or trap the power cable.
• The appliance must be installed
according to the installation diagrams.
• If the appliance does not work correctly
after having carried out all the checks,
contact your local Authorised Service
Centre.
• Once the appliance has been installed,
please explain to the user how to use it
correctly.
5.3 Power limitation procedure (for
installer only)
In order to change the maximum power
draw of the appliance, it is necessary to
access the user menu (see “User menu”).
Once you enter the user menu, the first
option available is the one marked with the
code
U0
(see “User menu options table”).
1. The cooking zone display will show, at
the top, the symbol
alternating with
the number
.
2. The timer display instead shows the
factory set power (values expressed in
Kw):
3. Press the left of the scroll bar to decrease
the power and the right to increase it.
Thanks to the
Eco-Logic Advance
function,
the power value increases and decreases
in 0.1 Kw steps with each touch.
To exit the user menu you can:
1. Press
for at least 2 seconds to save
the changes.
2. Press
to discard the changes.
In both cases the hob will be turned off and
will need to be turned on again.
.
Run the power cable in the rear
part of the unit. Make sure that it
does not come into contact with
the lower part of the hob or a built-
in oven below it.
Be careful when connecting
additional electrical appliances.
Connection cables must not come
into contact with hot cooking
zones.
