Smeg PLD18, Instruction Manual, Page: 6 / 18

Instructions for the installer
26
2.4
Supporting base
Make two openings in the rear part of the base as described in the figure
below. The left opening must be used for gas connections, and the right
one for electrical connections. Before securing the hob to the supporting
base, make 4 holes 8mm in diameter at the indicated points through which
the screws will pass that are to be secured into the rivets in the bottom part
of the product.
660 mm
150,1 mm
300 mm
35 mm 100 mm 490 mm 200 mm
90 mm
Ø
8 mm
119. mm 9
Z
90 mm
Ø
8 mm
Ø
8 mm
Ø
8 mm
The interaxes of the holes and the dimensions of the openings refer to a
hob installed against the back wall.