Instructions for the user
28
8.
CLEANING AND MAINTENANCE
Before any intervention, disconnect the power supply of the device.
8.1
Cleaning the glazed ceramic hob
The cooking hob should be regularly cleaned; best after every use, once the residual heat signal
lamps have gone off.
Smudges from aluminium-bottom pans can be easily cleaned off with a cloth
dampened in vinegar.
Remove any burnt residues after cooking with the scraper provided; rinse with water
and wipe dry with a clean cloth. Regular use of the scraper considerably reduces the
need for chemical detergents for the daily cleaning of the hob.
Never use abrasive or corrosive detergents (e.g. cleaning powders, oven sprays,
spot-removers, wire sponges).
8.2
Cleaning stainless steel
8.2.1
Ordinary Daily Cleaning
To clean and preserve the stainless steel surfaces, always use
only
specific products that do not
contain abrasives or chlorine-based acids.
How to use:
pour the product on a damp cloth and wipe the surface, rinse thoroughly and dry with a
soft cloth or deerskin.
Do not use metallic sponges or sharp scrapers: they will damage the surface.
Use normal non-abrasive products for steel, and a wooden or plastic tool if necessary.
Rinse thoroughly and dry with a soft cloth or deerskin.
Do not allow residues of sugary foods (such as jam) to set inside the oven. If left to set for
too long, they might damage the enamel lining of the oven.
NEVER USE A STEAM JET TO CLEAN THE APPLIANCE.
9.
SOMETHING WRONG?
PROBLEM
POSSIBLE CAUSES
WHAT TO DO?
The hob doesn’t work
-
The hob is not wired in or
switch on at the wall.
-
There is a power failure
-
Switch on at the wall
-
Check power supply
The results of cooking are
unsatisfactory
-
Temperature is too high or
too low
-
Wrong shelf position
-
Wrong type of dish
-
Cooking time is incorrect
-
Consult cooking tips
The hob smokes
-
The hob is dirty
-
Food has spilled over
-
Clean the hob once cooking
is finished. Let it cool first.
-
Use a larger pan
The plates do not come on
during timed cooking
-
Timed cooking programming
error.
-
Check the instruction for
timer
The front panel will light up but
the plates will not switch on
-
DEMO mode is now
activated
-
Refer to paragraph “7.2.11
“DEMO” mode” for how to
deactivate DEMO mode
