7
5. Attach the Fan Cover Bracket to unit with the 4
screws removed in step 1 above. See Figure 16.
The Hood Fan Unit is now rotated for vertical
exhaust operation.
Wire box
Figure 16
6. Attach the Exhaust Damper Assembly to the fan
cover on the top of the outercase cabinet by sliding
it into the slits in the same direction as the arrow.
Use 1 Tapping Screw 4 X12 mm from the INSTAL-
LATION HARDWARE and tighten into place. See
Figure 17.
Exhaust damper assembly
Figure 17
9. OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED
WITHOUT REFERRING TO THE MOUNTING IN-
STRUCTIONS FOUND ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON
BOTH TOP CABINET AND WALL TEMPLATES.
MOUNTING PLATE
1. Separate 4 Toggle Bolts 2, packed in the INSTALLA-
TION HARDWARE, from the Toggle Nuts.
2. Use Wood Screws 1 to attach Mounting Plate to the
stud or studs. Use Toggle Bolts to attach Mounting
Plate through the holes at A, B, C and D; UNLESS
THOSE HOLES ARE LOCATED ON THE STUD.
Insert one Toggle Bolt into A, B, C and D where ap-
propriate (these correspond to the holes of the Wall
Template) and put the Toggle Nuts onto the Toggle
Bolts. Figure 18.
Refer to instructions in Wall Template.
Mounting
plate
Figure 18
3. Position the Mounting Plate with the Toggle Bolts
attached at the wall location and insert Toggle Nuts
and Bolts through the holes in the wall with the Toggle
Nuts closed. Figure 19. Use Wood Screws 1 to attach
the Mounting Plate to studs.
Space more than
wall thickness
Wall
Figure 19
Note:
Before insertion, be sure you leave a space
more than the thickness of the wall between the
Mounting Plate and the end of each of the Toggle Nuts
(in the closed position). If you do not leave enough
space, the Toggle Nut will not be able to open on the
other side of the wall. Also, once a Toggle Nut opens,
it cannot be withdrawn from the hole; therefore make
sure all of the Toggles are in the correct position before
insertion.
4. Align the Mounting Plate carefully and hold in position
while tightening Toggle Bolts. Pull Toggle Bolt toward
you and turn clockwise to tighten. Figure 20.
Figure 20
