Smeg MP6322X, Manual

Page: 27 / 29

29 / EN
Installation
When the oven is operating I can hear some
strange noises! Check if:

There is any electrical arcing inside the oven
caused by foreign metallic objects (see
section on type of ovenware).

The ovenware is touching the oven walls.

There are any loose items of cutlery or
cooking tools inside the oven.
The food doesn’t heat up or heats very slowly!
Check if:

You have inadvertently used metal
ovenware.

You have selected the correct operating
times and power level.

The food you have put inside the oven is a
larger amount or colder than you usually put
in.
The food is too hot, dried out or burnt! Check
if:

You selected the correct operating time and
power level.
I hear some noises after the cooking process
is finished!

This is not a problem. The cooling fan keeps
on working for some time. When the
temperature has dropped sufficiently, the fan
will switch itself off.
The oven switches on but the interior light
does not go on!

If all the functions work properly it is probable
that the lamp has blown. You can keep on
using the oven.
If the problem has not been resolved or
in the case of other types of fault,
contact your local technical support
centre.
All repairs must be performed by
specialised technicians.
5.1. Electrical connection

The nameplate with the technical data, serial
number and mark is in a visible position on the
oven door frame.

The nameplate must never be removed.

The appliance must be connected to earth in
compliance with electrical system safety
regulations

If a permanent connection is used, the
appliance's power supply line must be fitted
with an omnipolar breaking device with contact
gap of at least 3 mm, located in an easily
accessible position close to the appliance itself.

If a socket and plug connection is used, check
that they are of the same type. Do not use
reducers, adapters or junctions since they may
cause overheating or burns.
5.2. Positioning the oven
The appliance is designed for building-in to
cabinets made from any heat-resistant material.
Comply with the dimensions shown in following
pictures (see 6. Installation Images).
When installing in tall units bear in mind that the
top/rear of the unit must have an opening 100 mm
deep.