9 - EN
This function protects the appliance from
being tampered by children. In this case, all of
the buttons are inactive except On/Off button;
by On/Off button you can whether stop or
resume (while child-lock on) the program of
your machine.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions
from the left for 3 sec. 1st auxiliary function
light will flash continuously. To deactivate the
child-proof lock, press the same buttons for
3 sec.
Ending the program through
canceling
In order to cancel the selected program,
press the “Start/Pause/Cancel” button for 3
seconds. The machine starts to discharge the
water. “Wash” and “Program Finished” lights
will light up. “Start/Pause/Cancel” and “Wash”
lights will go off after discharging process is
over and the “Lid” light will start flashing. “Lid”
lamp will light up continuously when the door
is unlocked.
If the program is cancelled in the middle of
the process, “Wash” and “Program Finished”
lights will light up. The machine can drain all
the water or can take in water for 3 times at
most to cool down the clothes and complete
draining process. When the water discharging
process is completed, the “Wash” light will go
off, the “Program Finished” light will light up
and the “Lid” light will continuously flash until
the door is unlocked.
End of program
The “Program Finished” lamp on the program
follow-up indicator will light up when the
program comes to an end. The lid is unlocked
2 minutes later, the “Program Finished” and
“Lid” lamps will light up continuously. The
machine is now ready for a second cycle.
If any key is pressed when the machine is at
the end of the program or if the position of
the selection knob is changed, the “Program
Finished” light will go off and only the “Lid”
lamp will remain as lit. If the door is still locked,
the “Lid” light will continue flashing until the
door is unlocked.
Press the “On/Off” button to shut down the
machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent the foreign substances and dirt in the
water to enter into the machine. Filters should
be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.