3 - EN
2 Installation
Removing packaging reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation locks
A
Transportation safety bolts must be removed
before operating the washing machine!
Otherwise, the machine will be damaged!
1. Loosen all the bolts with a spanner until they
rotate freely (“C”)
2. Remove transportation safety bolts by turning
them gently.
3. Fit the covers (supplied in the bag with the
Operation Manual) into the holes on the rear
panel. (“P”)
C
Keep the transportation safety bolts in a safe
place to reuse when the washing machine
needs to be moved again in the future.
C
Never move the appliance without the
transportation safety bolts properly fixed in
place!
Adjusting the feet
A
Do not use any tools to loosen the lock nuts.
Otherwise, they can be damaged.
1. Manually (by hand) loosen the lock nuts on the
feet.
2. Adjust them until the machine stands level and
firmly.
3. Important: Tighten all lock nuts up again.
Connecting to the water supply.
Important:
• The water supply pressure required to run the
machine must be 1-10 bar (0,1 – 1 MPa).
• Connect the special hoses supplied with the
machine to the water intake valves on the
machine.
• If you are going to use your double water-inlet
machine as a single (cold) water-inlet unit, you
must install the stopper*, supplied with your
machine to the hot water valve.
• If you want to use both water inlets of the
product, you can connect the hot water hose
after removing the stopper and gasket group
from the hot water valve.
* Applies for the products supplied with a blind
stopper group.
• Models with a single water inlet should not be
connected to the hot water tap.
When returning the appliance to its place after
maintenance or cleaning, care should be taken not
to fold, squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be attached to the
edge of a washbasin or bathtub. The drain hose
should be firmly fitted into the drain as to not get
out of its housing.
Important:
• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
• The hose should be attached to a height of at
least 40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on
the floor level or close to the ground (less than
40 cm above the ground), water discharge
becomes more difficult and the laundry may
come out wet.
• The hose should be pushed into the drainage
for more than 15 cm. If it is too long you may
have it shortened.
• The maximum length of the combined hoses
must not be longer than 3.2 m.
Electrical connection
Connect the machine to an earthed outlet
protected by a fuse of suitable capacity.
Important:
• Connection should comply with national
regulations.
• The voltage and the allowed fuse protection
are specified in the section “Technical
Specifications”.
