Smeg LB107-1, Instructions For Use Manual, Page: 22 / 32

242221
• Insert the fi lter back as shown on the picture (arrow and
pointer), and tighten by turning it in clockwise direction. To
ensure good sealing the gasket surface (A) must be dirt free.
(depending on the model) (depending on the model)
If the washing machine identi fi es failures in the operation, it reports it immediately. Sound alarm is
heard and the display reads ERROR. Number identi fi es the type of failure.
In some cases you may attempt removing certain failures yourself (see the chart below), and the
machine will continue to perform the operation after pressing the START knob (F). The machine
signals failures immediately after detecting them and stops the program, except for heater failure,
where the machine completes the washing program without heating water (FAILURE 1).
In case the machine signals faults you have to wait for at least 2 minutes before you
can open the door of the washing machine.
Interferences from the ambient (for example electrical wiring) could induce signalization of different
faults. In such cases:
- switch the appliance off, and wait for a few seconds;
- switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the environment (lightning
stroke, power supply circuit faults, natural disasters).
22
Failures