background image

15

Maintenance

Prior  to  any  maintenance  operation  ensure  that  the  cooker

hood  is  disconnected  from  the  power  supply.

Cleaning:

  The  cooker  hood  should  be  cleaned  regularly

internally  and  externally.

For  cleaning  use  a  cloth  moistened  with  denatured  alcohol

or  neutral  liquid  detergents.    Avoid  abrasive  detergents.

Warning: 

    Failure  to  carry  out  the  basic  standards  of  the

cleaning  of  the  cooker  hood  and  replacement  of  the  filters

may  cause  fire  risks.

Therefore  we  recommend  observing  these  instructions.

Grease  filter

This  must  be  cleaned  once  a  month  (or  when  the  filter

saturation  indication  system  –  if  envisaged  on  the  model  in

possession  –  indicates  this  necessity  –  see  previous  page)

using  non  aggressive  detergents,  either  by  hand  or  in  the

dishwasher,  which  must  be  set  to  a  low  temperature  and

a  short  cycle.   

When  washed  in  a  dishwasher,  the  grease

filter  may  discolour  slightly,  but  this  does  not  affect  its  filtering

capacity.

 

To  remove  the  grease  filter,  pull  the  spring  release

handle 

(f) 

-  (Fig.  2).

Charcoal  filter  (filter  version  only)

It  absorbs  unpleasant  odours  caused  by  cooking.

The  charcoal  filter  can  be  washed  once  every  two  months

(or  when  the  filter  saturation  indication  system  –  if  envisaged

on  the  model  in  possession  –  indicates  this  necessity  –  see

previous  page)      using  hot  water  and  a  suitable  detergent,

or  in  a  dishwasher  at  65°C  (if  the  dishwasher  is  used,  select

the  full  cycle  function  and  leave  dishes  out).

Eliminate  excess  water  without  damaging  the  filter,  then

remove  the  mattress  located  inside  the  plastic  frame  and  put

it  in  the  oven  for  10  minutes  at  100°  C  to  dry  completely.

Replace  the  mattress  every  3  years  and  when  the  cloth  is

damaged.

Remove  the  filter  holder  frame  by  turning  the  knobs  (

g

)  90°

that  affix  the  chimney  to  the  cooker  hood 

(Fig.  3)

.

Insert  the  pad 

(i) 

of  activated  carbon  into  the  frame 

(h)

  and

fit  the  whole  back  into  its  housing 

(j)

.

It  is  possible  to  use  a  traditional  carbon  filter,    neither

washable  nor  regenerable,  to  be    replaced  every  3  -  4

months.

The  filter  holder  frame  of  the  carbon  filter  is  welded  together;

the  eventual  frame  supplied  with  the  hood  is  not,  therefore,

to  be  used.

Insert it into its housing and fix it turning the 2 plastic knobs.

Replacing  lamps  -  Fig.  4

Warning!

Prior  to  touching  the  light  bulbs  ensure  they  are  cooled  down.

For  models  shown  in  Fig.    1A:

1.

press  on  the  lamp  cover  and  release  to  open.  (

fig.  4A

).

2.

Replace the damaged light bulb.

Only use halogen bulbs of 20W max (G4), making sure you do

not touch them with your hands.

3.

Close the lamp cover (it will snap shut).

For  models  shown  in  Fig.    1B-1C-1D-1G-1H:

1.

Extract the guard by levering it off with a small screwdriver or

similar tool.. (

fig. 4B

).

2.

Replace  the  damaged  light  bulb.

Only use halogen bulbs of 20W max (G4), making sure you do

not  touch  them  with  your  hands.

3.

Close  the  lamp  cover  (it  will  snap  shut).

For models shown in Fig.   1E:

1.

Use a small screwdriver as a lever on the borders of the lamp in

order to remove the lightbulb. (

fig. 4C

).

2.

Slide out the lightbulb to be replaced and replace with a new 12V

20W  30°  Ø35  12V  GU4  PHILIPS  STANDARD  LINE  code

425409.

If the lights do not work, make sure that the lamps are fitted

properly  into  their  housings  before  you  call  for  technical

assistance.

Caution

This appliance is designed to be operated by adults. Children should

not be allowed to tamper with the controls or play with the appliance.

Do not use the cooker hood where the grill is not correctly fixed!  The

suctioned air must not be conveyed in the same channel used for

fumes discharged by appliances powered by other than electricity.

The  environment  must  always  be  adequately  aerated  when  the

cooker hood and other appliances powered by other than electricity

are used at the same time.  Flambé cooking with a cooker hood is

prohibited. The use of a free flame is damaging to the filters and may

cause fire accidents, therefore free flame cooking must be avoided.

Frying of foods must be kept under close control in order to avoid

overheated  oil  catching  fire.  Carry  out  fumes  discharging  in

accordance with the regulations in force by local laws for safety and

technical  restrictions.

This  appliance  is  marked  according  to  the  European  directive

2002/96/EC  on  Waste  Electrical  and  Electronic  Equipment

(WEEE).  By  ensuring  this  product  is  disposed  of  correctly,  you

will  help  prevent  potential  negative  consequences  for  the

environment  and  human  health,  which  could  otherwise  be

caused  by  inappropriate  waste  handling  of  this  product.

The  symbol 

  on  the  product,  or  on  the  documents

accompanying  the  product,  indicates  that  this  appliance  may  not

be  treated  as  household  waste.  Instead  it  shall  be  handed  over

to  the  applicable  collection  point  for  the  recycling  of  electrical  and

electronic  equipment.  Disposal  must  be  carried  out  in  accordance

with  local  environmental  regulations  for  waste  disposal.

For  more  detailed  information  about  treatment,  recovery  and

recycling  of  this  product,  please  contact  your  local  city  office,

your  household  waste  disposal  service  or  the  shop  where  you

purchased  the  product.

Summary of Contents for KSIV960X1












Reviews: