Page 2 of 3
2.4
– Operation
The Oven Hood will be turned on by the front switch (Fig. 2)
Figure 2
3.
Maintenance
Attention!!! – Before carrying out any maintenance operations, turn off
the current by using the appropriate switch or disconnecting the plug.
Attention!!! – Any maintenance operation must be carried out by
qualified personnel only.
Maintenance operations may include the removal the panel
cover. To remove the panel cover unscrew the perimetric screws (Fig. 3)
and take care not to damage the electric cables when lifting the cover.
Figure 1
Attention!!! – When removing the panel, handle them with great
attention by using gloves to protect hands from possible cuts.
3.1 – Disassembling labyrinth filters
To disassemble the filters, grab and slide them upwards so that they
slip out of the lower guide. Rotate the lower wall slightly to release the
filter completely. To reassemble the filters, follow the procedure
reversely.
3.2 – Disassembling the fan
The fan is removed by removing the cover and disconnecting the
same from the cable. After removing the front cover to which is attached
the fan you can proceed to remove the screws that fixed the fan to the
cover.
3.3 – Disassembling the switch ON OFF
Before removing the switch must be removed the cover panel
mounted on the oven hood, fixed by screws (Fig. 4).
Figura 2
3.5 Spare parts
It is possible to use original or authorized spare parts only. Do not
repair or replace any components of the oven hood that have not been
recommended by this manual. All the other interventions must be carried
out by authorized technical personnel. To ask for a spare part, indicate
the hood model specified on the label.
The spare parts that can be supplied are the following:
I.
Switch ON OFF black 10 A;
II.
Fan 7/7 - 145 W 4P;
III.
Labyrinth filter 400 x 350 mm - GF032;
IV.
Eletrical wiring;
V.
Fixing brackets to the oven.
Switch
cover
Switch
Cover pannel