2
Transport instructions
The appliance should be transported only in
upright position.
Before the performance of the working test in
the shop, the packing of the appliance must
be intact.
After a transport in the horizontal position, the
device may only be taken into operation 4
hours after being stood up vertically again.
The appliance must be protected against rain,
moisture and other atmospheric influences.
The manufacturer assumes no liability if
safety instructions are disregarded.
Disposal
Make the device unusable immediately.
Pull out the mains plug and cut the power
cable. Remove or destroy snap or latch locks
before disposing of the device. In this
manner you prevent children from locking
themselves in and endangering their lives.
Device setup
• Do not operate your appliance in a room
where the temperature is likely to fall below
10 °C at night and/or especially in winter. At
lower temperatures the appliance may not
operate, resulting in a reduction in the storage
life of the food.
• The climate class rate of your appliance is
given in Technical Features leaflet and written
on the rating label inside the appliance. It
specifies the appropriate operating ambient
temperatures as explained below.
Climatic class
Ambient temperatures
SN …………….......
+10
o
C to 32
o
C
N ……………........
+16
o
C to 32
o
C
ST ……………........
+16
o
C to 38
o
C
T………………........
+16
o
C to 43
o
C
SN-
ST…………......
+10
o
C to 38
o
C
SN-
T…………….....
+10
o
C to 43
o
C
Location
Only place the appliance, as shown in the
illustration in dry rooms which can be aired.
Avoid direct sunlight or direct heat sources
such as a stove or a heater.
If this cannot be avoided, the following
minimum distances should be maintained:
Electric stoves: 3,00 cm
Heater: 3,00 cm
Cooling devices: 2,50 cm
• Ensure sufficient air circulation for your device.
• Make sure that sufficient room is provided
around the appliance to ensure free air
circulation
(Item 3)
.
Fit the two plastic wall spacers supplied with
the appliance rotating 1/4 turn to the condenser
at the back of the appliance
(Item 4)
.
• The appliance should be located on a smooth
surface. The two front feet can be adjusted as
required
(Item 5)
. To ensure that your appliance
is standing upright adjust the two front feet by
turning clockwise or counter-clockwise, until the
product is in firm contact with the floor.
Correct adjustment of feet avoids excessive
vibration and noise.
Electrical connections
Warning
This appliance must be grounded.
• Check whether the power type and voltage
in your region corresponds to the one stated
on the rating label inside the appliance.
• The electrical safety of the
appliance is only
assured when the grounding system in the
house is installed in accordance with regulations.
• When placing the appliance, do not let the
power cable get stuck under it; otherwise the
cable will be damaged.
• Ensure that the plug remains
readily
accessible. Do not use a multiple adapter bar
or an extension cable.
EN
Instruction for use
Summary of Contents for FC370B2PE
Page 4: ...2 1 ...
Page 5: ...3 5 4 8 6 7 9 10 ...
