User instructions
15
ANNULLING A PROGRAM
To annul the program
•
press
the
START/PAUSE
button
(3 )
for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
•
Keep
the
START/PAUSE
button
(3)
pressed until the
PROGRAM
PHASES
lights (5) go out (confirmation beep). “
P0
” will appear on
the
DISPLAY
and pump-out of the water in the tank will begin,
ending the program at the point where it was interrupted. When the
operation is complete, the
PHASES/PROGRAM LIGHTS (5)
flash.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted. When the operation is complete, the
PROGRAM PHASES
lights
(5)
flash.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM
”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 60 seconds later.
OPTION SELECTION
Options are selected by pressing the relative button by the symbol of the
option required; the light comes on to confirm that the option has been
activated.
•
It is not possible
to select any options when the
soak
program
is being used.
•
All
options
except "Flexi Tabs"
are
disabled
at the end of the
wash cycle. To
disable the “Flexi Tabs” option, press
the
relative button (the light goes out).
•
All options, including
"Flexi Tabs"
are
disabled when a
program is
CANCELLED
after it has begun.
"Flexi Tabs"
The option is optimised for use of detergents which are complete with
salt and rinse aid. With this option activated, any salt and rinse aid If you
wish to use detergents which already contain salt and rinse aid already
in the dishwasher will not be used.
- N.B.:
even with the "
Flexi Tabs"
option selected, the
regenerating salt/rinse aid lights will still stay on if their
containers are empty.
IMPORTANT:
when no longer required, the option must be
disabled
by
pressing the relative
button
(the light goes out).
