User instructions
42
4. Operating instructions
Once the dishwasher has been correctly installed, prepare for use as
follows:
•
Adjust the water softening system;
•
Add the regenerating salt;
•
Add the rinse aid and detergent.
4.1 Using the water softening system
The amount of scale contained in the
water (water hardness index) can cause
whitish staining on the dry dishes, which
tend to become dull over time. The
dishwasher is equipped with an automatic
softening system which uses a special
regenerating salt to reduce the hardness
of the water.
The dishwasher is factory set for water
hardness level
3
(average hardness
41-60°dF
–
24-31°dH
).
When using water of medium hardness, the regenerating salt container
should be refilled after approximately
20 washing cycles
. The salt
container can hold approximately
1.5 Kg
of salt in grains. Some models
are equipped with an optical no-salt indicator. In these models, the cap
of the salt container contains a green float which descends as the salt
concentration in the water drops. When the green float can no longer be
seen through the transparent cap, the container must be topped up with
regenerating salt. The container is situated at the bottom of the
dishwasher. After removing the lower basket, unscrew the salt container
cap by turning it anticlockwise and pour in the salt using the funnel
supplied with the dishwasher. Before replacing the cap, remove any salt
residues from around the opening.
•
When using the dishwasher for the first time, in addition to the salt it
is also necessary to add
one litre of water
to the container.
•
Each time the salt container is refilled, make sure that
the cap is
securely closed
. The mixture of water and detergent must never
penetrate the salt container, as this would compromise the operation
of the regeneration system. In the event of this occurring, the
warranty will be invalidated.
•
Only
use regenerating salt specially formulated for domestic
dishwashers. If using salt tablets,
do not fill the container
completely
.
SALT
