User instructions
18
N.B.:
When the salt and rinse aid containers are empty, the relative lights will
remain on even if the
“Flexi Tabs”
option is selected.
IMPORTANT:
when no longer required, the option must be
deactivated
by pressing
the relative
button
(the light goes out).
If the water hardness has been set on a value above H3, and the “Flexi
Tbas” option is activated, the relative light flashes, warning of a setting
error. Multi-function products are not suitable for use with very "hard"
water; this does not prevent the use of the option, but the washing
results might not be of the best.
HYCLEAN
Increases the temperature of the final hot rinse to 70°C to ensure a further
reduction in the bacteria level. If the temperature in the tank falls during
this stage of the program (e.g. because the door is opened or due to a
power blackout), the light of the option and the program lights flash to warn
that the additional washing phase has not been completed successfully.
This does not mean that the wash program has been less effective than
usual.
SPREAD HALF LOAD
Suitable when there are not many dishes to be washed, it saves energy
and reduces the program duration. Place dishes in both baskets then
load the detergent dispenser than less than the normal amount for a full
load.
PROGRAM DELAY
The
PROGRAM DELAY
button can be pressed to delay the start of the
washing program by from 1 to 12/24 hours depending on the model. This
option allows the dishwasher to be operated at the time of day of the user's
choice. The first time the
PROGRAM DELAY
button is pressed the option
light comes on and 1:h appears on the
DISPLAY
(9). The button can then
be pressed again, to set the delay required (
2:h, 3:h
, … etc.). If no button is
pressed for a few seconds, the
DISPLAY
(9) shows the time left (time
remaining) to the end of the selected program (e.g.
5:40
, duration of the
washing cycle + program delay). When the user confirms the program start
(read the relative section) a prewash will be carried out, after which the
PROGRAM DELAY
set will begin, and the time remaining on the
DISPLAY
will gradually be counted down. At the end of the delay set, the option light
goes out and the washing cycle starts.
N.B.:
It is not possible to select the
PROGRAM DELAY
option once the
cycle has begun.
